This winter we’ll leave our 11-ton Mercedes Unimog expedition truck in Mongolia.
Temperatures here can fall below –40°C, so careful preparation is essential if we want to find everything intact when we return in spring.
After talking to locals and other overlanders who have left their trucks in Siberia and Alaska, we’ve created our own step-by-step plan — combining theory with hard-earned experience.
🔧 Engine and Heating Systems
We replaced both the engine coolant and the cabin/floor-heating coolant with a –40°C mix (Glysantin G48 or equivalent).
Before shutdown, we ran the engine and the circulation pumps for 15 minutes to make sure the new coolant reached every hose and heat exchanger — no air pockets left to freeze.
🚿 Water System
All tanks, pipes, and the boiler were completely drained.
Then we used the truck’s engine compressor at low pressure to blow the lines clear.
Taps are left slightly open to allow for any expansion.
☕️ Coffee Machine
Our coffee machine needed special attention: we ran it dry, blew air through the inlet hose, and flushed it with a 50/50 water–alcohol (Vodka) mix to avoid freezing and corrosion in the small internal pipes.
🚽 Toilet
The black water tank was emptied and a little antifreeze added to both the flush tank and the bowl.
We ran the flush once so all seals stay flexible during the deep freeze.
🪫 Power, Diesel & Electronics
All batteries were fully charged before we left.
We kept the AGM batteries connected. (Lithium is supposed to be stored indoors, I read.)
The diesel tank was filled up and treated with anti-gel additive.
Our Victron system was set to float mode, and sensitive displays (like the GX Touch) hopefully do not get damaged.
🏠 Inside the Living Unit
We removed everything that could burst — liquids, sprays, soaps, and paints.
Fabrics and bedding were stored dry, and we placed a few moisture absorbers throughout the cabin.
One roof vent remains slightly open for ventilation, and the fridge doors are propped open to prevent mould.
💡 Extra Tips from Other Overlanders
– Add –40°C windshield fluid to sink traps.
– Test coolant with a refractometer; never guess the mix.
– Diesel additive is crucial; local fuel can start gelling around –25°C.
– Keep a printed checklist with fluid types and refill dates for next season.

We have a little 980 Watt heater which switches on when the temperature drops below 5°C. We used this in Kazakhstan, but it needs a stable 230V connection.

